Date of Award
1992
Document Type
Thesis
Publication Status
Version of Record
Submission Date
October 2026
Thesis/Dissertation Advisor [Chair]
Hartt, William H.
Abstract
Experiments have been performed which determined the fatigue crack growth rate (FCGR) of short cracks (a > 0.1mm) for five high strength steels (yield stress 370-570 MPa) in air and in natural seawater with and without cathodic protection. Attention was focused upon Regions I and Il of the classical FCGR-stress intensity range(Delta K) curve with particular consideration of the near-threshold behavior for short cracks. Single edge notch (SEN) three-point bend specimens and a direct current potential drop (DCPD) crack monitoring system were employed, and test parameters simulated offshore structure conditions. The results indicated enhanced FCGR for short cracks compared to macrocracks by 3-20 times in air and 2-6 in seawater free-corroding(FC). Also, the Delta Kth for short cracks was apparently lower than for long ones in both environments. The transition from short to long crack behavior occurred at constant $\Delta$K in each environment (15.6 MPa m in air and 10.0 MPa m in seawater(FC)) irrespective of initial Delta K (Delta K(0)). The transition crack length ranged from 0.25 to 1.6 mm and was inversely proportional to $\Delta$K(0). Scanning electron microscope fractography showed that the mechanism of enhanced crack growth rate was associated with secondary crack (SC) formation in air and SC or inter-granular cracking (or both) in seawater (FC). The enhanced FCGR for short cracks was minimized by polarization to -950 mV(SCE). Through an elastic-plastic fracture mechanics analysis using the J-integral parameter it was found that the influence of plastic deformation at the crack tip was approximately independent of crack length (short versus long), and the linear-elastic fracture mechanics analysis gave a realistic representation for fatigue behavior.
Extent
235 p.
Recommended Citation
Kim, Kijoon., "Fatigue crack growth rate of short cracks for high strength steels in sea water" (1992). Electronic Theses and Dissertations 1990 - 1999. 308.
https://digitalcommons.fau.edu/etd_general_4/308
Identifier
FADT12313
Comments
College of Engineering and Computer Science|FAU Electronic Theses and Dissertations Collection|Thesis (Ph.D.)--Florida Atlantic University, 1992.|College of Engineering and Computer Science